The Sketcher Toolbar

To exit an option, you can:

Click another button
Press exit, returning to Select mode.
Deselect the button, returning to Select mode.

Note: For the Trim function, pressing exit will return you to the function you were using last, not necessary to Select mode. For instance, if you are creating an arc and then enter Trim, when you are finished trimming and press exit, you will return to the Arc function.

The Sketcher toolbar contains the following tools:

Select Entities

Select entities.

Rectangle

Create a rectangle with square or rounded corners.

Create a line.

Create a circle.

Create a dimension.

Create a sharp, round or chamfer corner between curves.

Offset

Offset curves.

Dynamic Trim

Trim curve portions that are cut by 2 other entities.

Add Reference

Add selected entities as reference entities in the sketch.

Add Constraint

Create constraints between entities.

Show Open Points

Show open end points of curves that are not connected to other curves.

Sketcher Tools

Display additional sketcher tools.

The following options are available:

	Load Sketch	Load an SKF file into the existing sketch.
	Save Sketch	Save the existing sketch to an SKF file.
	Insert Picture	Insert and embed external graphic files into existing sketches.
	Constraint Filter	Define which constraints will be highlighted and created automatically.
	Show Open Points	Show open end points of curves that are not connected to other curves.
	Close Points	Close the gap between open end points of curves by modifying the curves.
	Allow Auto Reference	Allow the Sketcher to take automatic references (taken for visible entities without adding them as references).
	Show Auto Reference	Show automatic references (taken for visible entities without adding them as references).
	Delete Constraints and Relations	Delete all dimensional and geometrical constraints and relations.
	Show Constraints	Show all the constraints in the entire sketch.
	Show Immediate Constraints	Show constraints that will be formed when creating new geometry, next to the cursor.
	Edit Sketch Orientation	Change the X and Y directions of the sketch.

Delete

Delete the selected item.